[VLADIMIR]

i JUST Replaced all the calipers and tried to bleed all the the lines. I did all the lines in order as it is called to do, but back right rear #4 is not bleeding and neither is front left wheel #8. I pump the brakes but no fluid shoots out of these points. The other points of bleeding were fine. Any suggestions or thoughts regarding this issue?


Thanks,

Vladimir

 

[BHart]

Since you've got only two giving trouble, it's probably not the master. The system is triangulated with half of each front caliper connected to one rear. There's a diagram in the Haynes manual showing which sides are interconnected so check that if you can just to be sure.

You'll need to force some fluid out. Try removing the bleed screw completely or you might try removing the brake line from the caliper.

There may be some crud in the lines somewhere and it will hopefully be pushed out if you give it an unrestricted path.

Just need more fluid.