Volvo Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi Folks

Im a newbie here and im after some advice. I am a tramper and run with a Volvo FH13 the keyfob is dodgy im planning on buying another does anyone know how i can re-programme one to work with my truck?

kind regards

gav mcelroy
 

·
Registered
Joined
·
1 Posts
hi try this

Programming a truck equipped with an alarm is the same as programming one with only central locking, except that the direction indicators do not light during programming.
Coding of new remote controls (max 8 units for the new control unit with green connector block and max 4 units for old version of control unit, blue connector block):
Note: When performing re-programming, the first remote control that is programmed, must have been programmed for the that control unit (ECU) earlier. If none of the old remote controls function, then the control unit must also be replaced.

Remote controls that are not reprogrammed in the same programming sequence as the other remote controls will not function.

Note: The ignition must be turned on and off quickly and in succession. The instrument shall not be activated.
  1. Turn the ignition key to the drive position and off again 5 times.
  2. Leave the key in the drive position the 5th time.
  3. The direction indicators remain lit all the time in the programming mode.
  4. Press button 1 or 2 on the remote control unit.
  5. The direction indicators go out for about 1 second to show that they have received the new remote control unit.
  6. Continue directly with the next remote control unit. The system returns to its normal state 15 seconds after the last button press or if the ignition is switched off.
Note: If none of the buttons on the remote control are pressed, the old remote controls will continue to function.
All remote controls should be checked after programming is completed.
 
1 - 2 of 2 Posts
Top