Volvo Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
:confused:The timing belt broke on my '99 V70 XC AWD and I'm looking at close to $1,000 to replace it with a rebuilt head and labor. I'm thinking that I'd be better off with a lower mileage engine. They say that only another 99 B5254T will fit but I read on this forum about a guy who swapped a 2001 B5244T3 into his '99 V70 XC with absolutely no problems mounting things right up. Is anyone else familiar with what other engines and years will fit? I'm not sure why other engines/years won't fit since the block casting is the same, isn't it? What about the electronics and wiring harness? THANKS for the help! :confused:
 

· Registered
Joined
·
46 Posts
99 to maybe 06. not too sure. You will need to use your harness and especially the electronic throttle control from your car. The new engine probably wont have the intake attached anyway. remember to get new exhaust and intake gaskets, new rear main seal. Good time to install a new timing belt and seals and water pump while the engine is out of the car. Also the best time to install new motor mounts if they are weak. It's a lot of work. Done it a few times already. Good luck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top